Cruising Sailors Forum Archive
Just a Group 24 or 27 Cranking Battery works fine.
In Response To: What do you typically use for a battery? 
()
() Make sure you have good jumper cables. They will warm up a bit but shouldn't get hot for the 10-15 seconds you have contact. I don't wait for anything to get red hot. If it is a SS screw it will start to discolor - "wheat" is the technical term in heat treating.
Messages In This Thread
- Frozen SS screw in an aluminum frame, looking for suggestions ....
- got a drill?
- Try and remove them with the impac driver and
- If there would be ...
- Jumper Cables
- You saved me the trouble of describing the jumper cable trick
- What do you typically use for a battery?
- Just a Group 24 or 27 Cranking Battery works fine.
- What do you typically use for a battery?
- When I was working I had to check
- You saved me the trouble of describing the jumper cable trick
- Jumper Cables
- Try a GraBit Damaged Screw Remover. Worked well for me
- Canned Air?
- I don't think you'll break the screw.
- got a drill?