Cruising Sailors Forum Archive
I think you could have done it if you steamed the piece
In Response To: A mating flange: I realized, no way a solid piece will make the bend,... ()
A couple of hours in the steam box and a solid piece would have bent. Route the cutout in after bending. You could also have laminated it with full length stock. I would probably have gone with a laminated build from 1/4" strips, but then I like to make laminations.
Messages In This Thread
- A mating flange: I realized, no way a solid piece will make the bend,...
- I think you could have done it if you steamed the piece
- Re: A mating flange: I realized, no way a solid piece will make the bend,...
