Cruising Sailors Forum Archive
lol- Yeah, we have. I glassed 6 feet of deck once, with epoxy resin
In Response To: ...we've all done this at one time or another 
()
() This on a 35 foot tri. Next day it was totally uncured. Finally figured out that THAT batch of resin didn't get any hardener at all. Huge mess!!
Tom- try warming the whole area, and give it a couple of days.. It should eventually kick, unless the MEKP was bad. Might be, but doubtful. I'd bet the temps are too low.
Messages In This Thread
- I took the advice of a few here to seal up my dinghy seams
- I've had the same problem on several of occasions over the years. With mixed results, I've
- When you say won't cure, to what extent are you referring?
- Only time and ambient temp. will help you now.
- Ack......so what about painting over a sticky surface?
- How about tenting it outside and get some heat in there.
- your catalyst (hardener) is probably stale
- Larry has a good point
- ...we've all done this at one time or another
- lol- Yeah, we have. I glassed 6 feet of deck once, with epoxy resin
- ...we've all done this at one time or another
- Larry has a good point
- How about tenting it outside and get some heat in there.
- Ack......so what about painting over a sticky surface?
