Cruising Sailors Forum Archive
Thanks Brian ... I was hoping no one would say that ... 
In Response To: You could drill out the Tides Marine... ()
... that's my fear, the Collar will be a bitch to get off ... and why I like the SS Collar SG sent along. I have to check the height, I think it is 1.5", and if so the same as mine. Hoping the drill holes are the same. Cheers, John
Messages In This Thread
- A Rudder Stop Collar question ...
- Torlon is really good stuff
- john, can you take picture with a cell phone or digital camera?
- Thanks, not sure I understand your suggestions ...
- For your Tartan 40, that should be an Edson Steering system?
- Tides Marine - 3.5" diameter Shaft -
- Answers ...
- You could drill out the Tides Marine...
- Thanks Brian ... I was hoping no one would say that ...
- Thanks Brian ... I was hoping no one would say that ...
- If the Delrin is really being "plolished" or "ground" by the load, it will wear over time
- You could drill out the Tides Marine...
- For your Tartan 40, that should be an Edson Steering system?
- Thanks, not sure I understand your suggestions ...
- Delrin AF is probably as good a choice as any...
