Cruising Sailors Forum Archive
On this note...
In Response To: Most states... ()
when using the tape in rather cold temps (a little above freezing to never above 50) is it advisable to apply a little heat to speed up the tightening down process? I have been holding off bedding some larger pieces (solar vent, hawes pipe) because I am afraid it will not compress evenly.
Messages In This Thread
- ports
- Use butyl rubber calk or tape
- get it here
- What have you used this on? Time frame?
- I am using this on my Ariel right now.....
- Hmmm. It sounds 'easy'...speaking of why things take so long....
- P.S. Ain't it the trut'! Each idea leads to another and another and before long you rebuilt the boat.
- Agreed, although you do still have to have other stuff for...
- Yes, the "never again" was a bit of an exaggeration
- Sometimes you need "splooge", you can't get that with this.
- Hmmm. It sounds 'easy'...speaking of why things take so long....
- Hey Westie, I have some.
- I am using this on my Ariel right now.....
- How temperature dependent is this butyl for installation?
- I replaced the fixed ports on my C&C27 last summer
- Use butyl rubber calk or tape
(Just had the topic on my mind as I was deciding what to use for fuel fills)