Cruising Sailors Forum Archive
I purchase ours when I needed to cut some plywood for overhead lighting.
In Response To: We also use 
()
() I figured that to have some guy make the cuts and round out the edges would cost about $100.00. I purchased the B&D kit instead (for less) and have used it many times since then.
Messages In This Thread
- Home Depot BEWARE!
- Did you buy separate "batteries" or just the drill w/ the original two-sets?
- HD
- I wired a Makita 9.6 volt drill that way. Ran fine on the 12 volt
- I made a long 12 volt wire with battery clips for our B&D multi tool set.
- We also use
- I purchase ours when I needed to cut some plywood for overhead lighting.
- We also use
- Ryobi drills
- Ridged needs to be registered. Had that problem myself. Different than Craftsman.
