Cruising Sailors Forum Archive
If the wire is tinned I'd always crimp
In Response To: Solder vs. crimp connectors ()
If bare copper wire, solder makes a connection that will last better. That said, I generally crimp even bare copper wires, but I spray a shot of CorrosionX on them.
Messages In This Thread
- Solder vs. crimp connectors
- Watch the type of solder, but otherwise it's fine to use solder.
- When you solder you make a rigid connection rather than flexible
- solder is better if done correctly
- I was always told to crimp if the amp draw was going to be high
- Crimp connectors with shrink tubing & sealant are really good.
- If the wire is tinned I'd always crimp
- Problem comes with the adjacent connection.
- I did note that some would say that solder is better; however, let's go to ABYC
