which is a good thing! I spend way too much time getting just the right tool to make just the right part, consequently I don't have enough time (in some folks judgement) to spend in Newfoundland! But I am getting to where I can make almost any part - I even recently got a small plastic injection molder. I was originally going to use the Sealand pieces, but at the time they were both special order and expensive.
I have talked to a couple places in Maine, both to Hinckley and the guys Peter M. recommended. I think either would be fine for me, so I am considering those possibilities. The only downside of that area is the travel from California is difficult. Probably have to fly to Manchester and drive up, which as I recall is quite a ways.