Cruising Sailors Forum Archive
So it would be one piece. Keep the bolts for Tom!
In Response To: I'm thinking of duplicating the original rudder in plywood and fiberglass reusing the bronze stock, Tom 
()
() Probably a lot easier to fabricate and make symmetric. Just need a good seal where the shaft is attached. A good-sized project!
Messages In This Thread
- Rudder Project
- Back in the shop
- (AKA Old Curmudgeon) There is nothing wrong with that rudder!
Throw it back in! 
- THink about adding a bit more body down low?
- I should give that some more thought, Westie
- That's a good thought. Rudder design put more surface down low about then.
- Ericson 35
- That doesn't look like an Ericson 35.......
- The rudder in that pic is more like the one I ended up building for the 32'.
- Paul, how does the rudder stock attach to the rest of the steering?
- The shaft continues 30" beyond the top of the rudder
- What is the joint that attaches the rudder stock to the shaft above?
- Oh, maybe it's one piece all the way through?
- What is the joint that attaches the rudder stock to the shaft above?
- The shaft continues 30" beyond the top of the rudder
- Ericson 35
- That's a good thought. Rudder design put more surface down low about then.
- I should give that some more thought, Westie
- Rudder Replacement
- Back in the shop
