Cruising Sailors Forum Archive
I hate when people do that. 
In Response To: The threads in the mixing elbow are reversed. ()
Why can't they stick with standards? Did you know before trying to get it apart?
I have one of those on the overboard discharge pump at the top left of this tank. Labeled it clearly because I knew it would be a problem at some point in the future, if I didn't.
Messages In This Thread
- Well still no joy with the engine. Yanmar 2GM20F
- Gene, have you checked the compression?
- Did you bleed at the injectors?
- Good decision to call an engine guy, Gene.
- That's normal for the clicker.
- pump lever
- ah, but I have rotated the engine several times...
- Often, the 2GM20...
- Ron, Greg Dlezynski suggested nearly the same thing.
- Gene, that particular...
- I have raw water turned off.
- One last little caviat...
- Will check. Just removed exaust elbow.
- I MAY HAVE FOUND THE PROBLEM!!!
- GOOD ON YOU Gene!
- I can pretty much guarantee you...
- Took the mixing elbow over to a friends house....
- GOOD ON YOU Gene!
- I MAY HAVE FOUND THE PROBLEM!!!
- Will check. Just removed exaust elbow.
- One last little caviat...
- I have raw water turned off.
- Gene, that particular...
- Ron, Greg Dlezynski suggested nearly the same thing.
- Often, the 2GM20...
- ah, but I have rotated the engine several times...
- This, from my basement, may look familiar.