Cruising Sailors Forum Archive
Re: Fiberglass saves space: Is a 3/4 inch gutter going to
In Response To: Fiberglass saves space, I need the wood structure around the gutter. ()
give you enough depth and width to accommodate the amount of run off water you can expect to land on the seats from time to time? My gutter is an inch wide and almost two inches deep.
Messages In This Thread
- A cockpit well.
- Hoisting points
- I will need some hoisting points.
- Complication I have is the two big cockpit locker tops.
- Are you planning to glass the entire inside of the cockpit well?
- The "modern" approach would be to have a gutter below the lids which drains out into the cockpit.
- That is what I'm doing.
- Sounds like a good plan. As regards the hinge side gutters others must have solved this previously.
- Pondering hinge side...seems my memory conures up the usual.....
- Here's a rough sketch in actual size of my plan.
- I think the gutters are too narrow, Tom.
- Fiberglass saves space, I need the wood structure around the gutter.
- why not build fiberglass locker lids....
- Re: Fiberglass saves space: Is a 3/4 inch gutter going to
- Fiberglass saves space, I need the wood structure around the gutter.
- Looks about right to me. Couple things I notice......idle curiosity.
- I think the gutters are too narrow, Tom.
- Here's a rough sketch in actual size of my plan.
- Pondering hinge side...seems my memory conures up the usual.....
- Sounds like a good plan. As regards the hinge side gutters others must have solved this previously.
- That is what I'm doing.
- Tom, bear in mind all those trim and joining pieces are there to deal with end grain exposure.
- Complication I have is the two big cockpit locker tops.
- I will need some hoisting points.
- You disappoint me, Tom
- Hoisting points
